14+14 watt stereo amplifier board DIY using TDA2030 ic.

14+14 watt stereo amplifier board DIY using TDA2030 ic.

This things are required to make this amplifier.........                   

1. 2×TDA2030 ic.........https://amzn.to/32Kl96j

2. 4×22kΩ resistor 1/4W.........https://amzn.to/2lqNNce

3. 2×680Ω resistor 1/4W.........https://amzn.to/2lq9Mjx

4. 2×10Ω resistor 1/4W.........https://amzn.to/2Q4n7wz

5. 4×100uf capacitor 25/63v.........https://amzn.to/2I1673Z

6. 2×22uf capacitor 50/63v.........https://amzn.to/2lqaTQf

7. 2×1uf capacitor 50/63v.........https://amzn.to/31dFpfZ

8. 6×100nf capacitor 50/63v.........https://amzn.to/2lqWQdc

9. 2×2200uf capacitor 25v.........https://amzn.to/32Bv0Ly

10. 4×1N4007 diode.........https://amzn.to/32A3Lks

11. 4×1N5408 diode.........https://amzn.to/2N9rS5J

Watch this video for better understanding

License► ©Technical Mriganka. You can't use this pcb layout for commercial purpose. You can use this pcb layout only for educational and diy projects.

Pcb Layout pdf file.........https://drive.google.com/file/d/1--mchRuxQUcen0a5mWekI7FbOoB126De/view?usp=drivesdk

In this post I make a 14+14 watt stereo amplifier board using TDA2030 ic. This ic is class AB amplifier [60hz-20khz]. This ic can make 14 watts output. For power supply you can use 12-0-12 volt 2 Amp transformer. Now follow my steps for this amplifier. First we make pcb. For make pcb you need pcb layout. download the pcb layout and print it by laser printer on photo paper. Then cut the pcb layout. Then press the pcb layout by iron on copper clad board. Press the iron 10-15 munites. Then leave the pcb for cool down 10 munites. when the pcb was cool, put the pcb in water and move the pcb layout to copper clad board. Then put the pcb in ferric chloride [FeCl3+H2O] for etching 10-15 munites. when etching was end, clean the pcb by water. Then make hole on pcb. And then press the upper side print of pcb. Now your pcb is ready mount components by instruction.

 Thank you,

Technical Mriganka.........