Low pass filter using 4558D ic 0-12 Volt .

This components are required to make this board.

1. 1×4558D IC

2. 1×LM7812 IC

3. 1×1000uf 25V capacitor.

4. 1×10uf 50V capacitor.

5. 1×4.7uf 50V capacitor.

6. 1×2.2uf 50V capacitor.

7. 1×1uf 50V capacitor.

8. 1×473pF 50V capacitor.

9. 1×470pF 50V capacitor.

10. 1×330pF 50V capacitor.

11. 1×104pF 50V capacitor.

12. 1×102pF 50V capacitor.

13. 2×200k resistor.

14. 1×150k resistor.

15. 1×68k resistor.

16. 2×10k resistor.

17. 2×2.2k resistor.

For Pcb

1. Copper clad board........https://amzn.to/2MdRE8o

2. Ferric chloride.......https://amzn.to/2KsO34n

3. Thinner /Nail Polish remover.........https://amzn.to/2TnKy1T

4. Photo paper.......https://amzn.to/2TmXIMz

Watch this video for better understanding

License► ©Technical Mriganka. You can't use this pcb layout for commercial purpose. You can use this pcb layout only for educational and diy projects.

Pcb layout PDF - https://drive.google.com/file/d/1-spEKBeVxLtgmxymY8CHlaXJ5vAaXA9X/view?usp=drivesdk

In this post I make a Low pass filter using 4558D ic and 0-12V power supply. Frequency 30-120hz.  For power supply you can use 0-12V 500mA transformer. Now follow my steps for this Low pass filter. First we make pcb. For make pcb you need pcb layout. download the pcb layout and print it by laser printer on photo paper. Then cut the pcb layout. Then press the pcb layout by iron on copper clad board. Press the iron 10-15 munites. Then leave the pcb for cool down 10 munites. when the pcb was cool, put the pcb in water and move the pcb layout to copper clad board. Then put the pcb in ferric chloride [FeCl3+H2O] for etching 10-15 munites. when etching was end, clean the pcb by water. Then make hole on pcb. And then press the upper side print of pcb. Now your pcb is ready mount components by instruction.

 Thank you,

Technical Mriganka.........